TutorialRapiData2014

We are in the so-called "Blue cubicle" close to the library (see "Sharp" on floor plan)

Content:

• Introduction
• Tutorial schedule
• Setup

Introduction

Here we will collect some information regarding use of our software (during tutorials or when using it on your own) that is particular to the setup during RapiData 2014.

Since not much has changed in the beamline setups, the following tutorials are still the best starting points:

• SHARP/autoSHARP tutorial
• autoPROC tutorial

We will try and keep this page here up-to-date as we get settled in during the course.

Tutorial schedule

We are doing tutorials for SHARP/autoSHARP (as well as autoPROC) in X23-room on

• Tuesday, 19:30 - 21:00 (in X25-cafe!)
• Wednesday:
• 10:00 - 12:00
• 13:30 - 15:00
• evening (on demand: please talk to us after the afternoon meeting or find us - see floor plan)
• Thursday:
• 10:00 - 12:00
• 13:30 - 15:00
• evening (on demand: please talk to us after the afternoon meeting or find us - see floor plan)

Any other time might also be possible - just find us if you have a problem, collected some data during the course or want to get more information, get a demo etc ...

Setup

Everything should be setup so that you can just type

% sharp

following the instructions printed at the end. If that doesn't work, please run

% source /usr/local/crys/GlobalPhasing/setup.csh

and try again.

If you don't get connected autmatically to the SHARP/autoSHARP interface at http://localhost:8081/, just type that location into your web browser (firefox).